Add Patch to Scene

Open the patches page, select the scene, where you want to add a patch to, and click "Add Patch" button below the scene selection. This will open a new page, where you can walk through the wizard for adding a new patch.

Components

Source Section

Select the visualization, which you would like to patch from. This will show you some additional information about the selected patch source, including the dimensions of the visualization.

Target Section

After you have selected a visualization in the source section, select a bridge and corresponding bridge channel where you want to patch the source to. This will show you some additional information about the selected patch target, including the dimensions of the bridge channel.

Configuration Section

After you have selected the patch source and target, you can configure the placement and size of the patch. On the left side, you can see a preview of the patch on the source canvas.

Info

When configuring a different patch size than the bridge channel dimensions, the rendered output will be automatically resized and centered to the channel, if required.